Ricoh D191 MPC401SP Z-C2

SP2-194-010 to -012 (Line Position Adjustment Result: M, C, Y)

This SP shows the number as a line position adjustment result on the LCD. It shows which color has an error (M, Y or C).

No.	Result	Description	Possible Causes/Action
0	Not done	Line position adjustment has not been done.	-
1	Completed successfully	Line position adjustment has correctly been done,	-
2	Cannot detect patterns	ID sensors have not detected the patterns for line position adjustment.	Line Position Adjustment
3	Fewer lines on the pattern than the target	The patterns, which ID sensors have detected, are not enough for line position adjustment.	Line Position Adjustment
4	More lines on the pattern than the target	Not used in this machine.	-
5	Out of the adjustment range	ID sensors have correctly detected the patterns for line position adjustment, but a shift of patterns is out of adjustable range.	Line Position Adjustment
6-9	Not used	-	-

Line Position Adjustment

When there are color registration errors on the output, do the line position adjustment as follows.

Test

1. Do SP2-111-003 (Mode c: rough adjustment).
2. Use SP2-194-007 to check if the result of the line position adjustment is correct (0: Completed successfully,
   1: Not completed). If the result is "1", refer to ‘Countermeasure list for color registration errors’.
3. Do SP2-111-001 (Mode a: fine adjustment twice).
4. Use SP2-194-007 to check if the result of the line position adjustment is correct (0: Completed successfully,
   1: Not completed). If the result is "1", refer to ‘Countermeasure list for color registration errors’.
5. Put some A4/LT paper on the bypass tray.
   • When you print a test pattern, use the bypass tray to feed the paper.
6. Print out test pattern "7" with SP2-109-003.
7. Check the printed output with a loupe.
8. If there are no color registration errors on the output, the line position adjustment is correctly done. If not,
   refer to the countermeasure list for color registration errors.