Ricoh D177 MPC2503 MET-C1

After Installing the New PM parts

1. Turn on the main power switch.
2. Output the SMC logging data with SP5-990-004 and check the counter values.
3. Make sure that the PM counters for the replaced units are "0" with SP7-944. If the PM counter for a unit was not reset, then reset that counter with SP 7-622.
4. Make sure that the exchange counter counts up with SP7-853.
5. Make sure that the counters for the previous units (SP7-908) on the new SMC logging data list (from step 2 above) are equal to the counters (SP7-803) for these units on the previous SMC logging data list (the list that was output in the "Before removing the old parts" section).
6. Make sure that the unit replacement date is updated with SP7-950.

Preparation before Operation Check

1. Clean the exposure glasses (for DF and book scanning).
2. Enter the user tools mode.
3. Do the "Automatic Color Calibration(ACC)" for the copier mode & printer mode as follows:
   • Print the ACC test pattern (User Tools Maintenance ACC Start).
   • Put the printout on the exposure glass.
   • Put 10 sheets of white paper on the test chart. This ensures the precise ACC adjustment.
   • Close the ARDF or the platen cover.
   • Press "Start Scanning" on the LCD. Then, the machine starts the ACC.
4. Exit the User Tools mode, and then enter the SP mode.
5. Perform line adjustment.
   SP2-111-004: Forced Line Position Adj. Mode d
   The result can be checked with SP2-194-007 (MUSIC Execution Result Execution Result)
   (0:Succeed, 1: Fail).
   Also, results for each color can be checked with SP2-194-010 to 013.
6. Exit the SP mode.

Operation Check

Check if the sample image has been copied normally.