Ricoh D159 MP2001L K-C4

Uploading Content of NVRAM to an SD card (D158/D159)

Do the following procedure to upload SP code settings from NVRAM to an SD card.

Note:

• This data should always be uploaded to an SD card before the NVRAM is replaced.
• Make sure that the write protection of an SD card is unlocked

1. Do SP5-990-001 (SMC Print) before you switch the machine off. You will need a record of the NVRAM settings if the upload fails.
2. Switch the machine main power switch off.
3. Remove the SD slot cover [A]
   
4. Insert the SD card into SD card slot 2 [B]. Then switch the machine on.
5. Execute SP5-824-001 (NVRAM Data Upload) and then press the “Execute” key.
6. The following files are coped to an NVRAM folder on the SD card when the upload procedure is
   finished. The file is saved to the path and the following filename:
   NVRAM\<serial number>.NV
   Here is an example with Serial Number “K5000017114”:
   NVRAM\K5000017114.NV
7. In order to prevent an error during the download, be sure to mark the SD card that holds the uploaded data with the number of the machine from which the data was uploaded.

Downloading an SD Card to NVRAM (D158/D159)

Do the following procedure to download SP data from an SD card to the NVRAM in the machine.

Important

• If copying of the data required for NV-RAM replacement fails, you need to specify the region and serial number when you replace the NV-RAM
• Contact your supervisor for details on how to enter the serial number and destination code.
• SC995 or "Fusing Unit Setting Error" can be shown until the serial number and destination code are correctly programmed.

Note:

• The NVRAM data download may fail if the SD card with the NVRAM data is damaged, or if the connection between the controller and BCU is defective.
• Do the download procedure again if the download fails.
• Do the following procedure if the second attempt fails: Enter the NVRAM data manually using the SMC print you created before uploading the NVRAM data.

1. Switch the machine main power switch off.
2. Remove the SD slot cover [A]
   
3. Insert the SD card with the NVRAM data into SD Card Slot 2 [B].
4. Switch the machine main power switch on.
5. Do SP5-825-001 (NVRAM Data Download) and press the “Execute” key.
   • The serial number of the file on the SD card must match the serial number of the machine for the NVRAM data to download successfully. The download fails if the serial numbers do not match.
   This procedure does not download the following data to the NVRAM:
   • Total Count
   • C/O, P/O Count