Ricoh D159 MP2001L K-C4

An SD card is used to update the controller firmware.

1. Setup a folder on the SD card, "model name”(E.g., "D161").
2. Rename the update file to“D161*****.brn”, and save under the relevant folder on the SD Card.
   • The name of the new firmware saved in the SD card should be made up of numbers ‘0’ to ‘9’ or characters “A” to “Z”. E.g., “D16103A34.brn” is correct, “D161_03A4.brn” is incorrect.
3. Remove the slot cover [A]
   
4. Insert the SD card into SD Card Slot 2 [B]. Make sure the label on the SD card faces the front side of the machine.
5. Turn the update switch (SW2) [A] on.
   
6. Turn the main power switch. "Please wait…" appears.
7. Press the "OK" key
8. Press “Execute”. Update will start.
9. After update is finished, turn off the main power, switch SW2 to OFF, and unplug the SD card.
10. Turn on the main power, then the new firmware will be working.

Note:

• During firmware update, there is no LED indication (no lighting).
• When update is finished, A Yellow LED [A] flashes if the update was OK or a Red LED [B] if the update failed.