Ricoh D142 MPC3502
Maintenance. PM Parts Settings 1
Before Removing the Old PM Parts
- Enter the SP mode.
- Output the SMC logging data with SP5-990-004.
- Set the following SPs to "1" before you turn the power off. Then, the machine will reset the PM counters automatically. In the case of developer, the developer initialization will also be done automatically.
- Exit the SP mode.
| Item | SP |
|---|---|
| Developer | Black: 3902-005 Yellow: 3902-006 Cyan: 3902-007 Magenta: 3902-008 |
| Drum Unit | Black: 3902-009 Yellow: 3902-010 Cyan: 3902-011 Magenta: 3902-012 |
| Heating sleeve belt unit and Pressure Roller (not necessary for complete fusing units; see below) | Heating belt: 3902-018 Pressure roller: 3902-019 |
| Image Transfer Belt Cleaning Unit | 3902-015 |
| PTR Unit | 3902-016 |
| Toner Collection Bottle (if not full or near-full) | 3902-017 |
- After the PM counter for the heating sleeve belt unit reaches its PM life (300K pages), the machine stops the operation automatically. Replace the heating sleeve belt unit before the machine stops its operation (stop warning: 315K pages, stop: 330K pages).
- Change the setting of SP3-902-018 from "0" to "1" before replacing the heating sleeve belt unit. Otherwise, the machine will not recover.
For the following units, there is a new unit detection mechanism. It is not necessary to reset PM counters.
- PCDU
- Development unit
- Toner Collection Bottle (if full or near-full)
- Fusing unit