Ricoh D133 MP9002
Firmware Update. Errors During Firmware Update
If an error occurs during a download, an error message will appear. The error code consists of the letter "E" and a number ("E20", for example).
Error Message Table
No. | Meaning | Solution |
---|---|---|
20 | Cannot map logical address | Make sure the SD card is installed correctly, or use a different SD card. |
21 | Cannot access memory | HDD connection not correct, or replace hard disk. |
22 | Cannot decompress compressed data | The ROM data on the SD card is not correct, or data is damaged. |
23 | Error occurred when ROM update program started | Controller program defective. If the second attempt fails, replace the controller board. |
24 | SD card access error | Make sure the SD card is installed correctly, or use a different SD card. |
30 | No HDD available for stamp data download | HDD connection not correct or replace hard disks. |
31 | Data incorrect for continuous download | Install the SD card with the remaining data necessary for the download, then re-start the procedure. |
32 | Data incorrect after download interrupted | Do the recovery procedure for the module, then repeat the installation procedure. |
33 | Incorrect SD card version | The ROM data on the SD card is not correct, or data is damaged. |
34 | Module mismatch - Correct module is not on the SD card | The data on the SD is not correct. Get the correct data (Japan, Overseas, OEM, etc.) then install again. |
35 | Module mismatch – Module on SD card is not for this machine | SD update data is not correct. The data on the SD card is for a different machine. Get the correct data then install again. |
36 | Cannot write module – Cause other than E34, E35 | SD update data is not correct. The data on the SD card is for a different machine. Get the correct data then install again. |
40 | Engine module download failed | Replace the data for the module on the SD card and try again, or replace the BCU board. |
42 | Operation panel module download failed | Replace the data for the module on the SD card and try again, or replace the LCDC. |
43 | Stamp data module download failed | Replace the data for the module on the SD card and try again, or replace the hard disk. |
44 | Controller module download failed | Replace the data for the module on the SD card and tray again, or replace the controller board. |
50 | Electronic confirmation check failed | SD update data is not correct. The data on the SD card is for a different machine. Get the correct data then install again. |