Ricoh D133 MP9002

TO SWITCH TO THE COPY WINDOW FOR TEST PRINTING

1. In the SP mode display, press Copy Window to switch to the copy operation screen when you need to select paper for a test print.
2. Use the copy window (copier mode) to select the appropriate settings (paper size, etc.) for the test print.
3. Press [Start] to execute the test print. 4. Press SP Mode (highlighted) to return to the SP mode screen and repeat from step 1.

Using the SP Mode

SP command numbers can be entered directly (if you know the entire number) or the command can be selected from the menus.

Direct Entry

SP5831 (Initial Setting Clear) an executable SP that initializes the User Tools settings, can be executed immediately by just entering the numbers.

1. Press [5] [8] [3] [1]
2. Press [#].
3. Press "Execute" on the touch panel.

If you know all seven digits of the SP code, enter the seven numbers and press Execute.However, if you do not know all the numbers, enter only the first four numbers of the seven-digit SP and press [#]. The display goes immediately to the first SP of that group. Then you can use the buttons to browse to the desired selection.

Button Selection Entry

1. Refer to the SP Mode Tables at the end of this section to find the SP that you want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the SP number that you want to open, then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item that you want to set, and press [#]. The small entry box on the right is activated and displays the default or the current setting below.
5. To enter a setting
   • Press [./*] to enter a minus sign. Then use the keypad to enter the appropriate number. The number you enter will write over the previous setting.
   • Press [#] to enter the setting. (If you enter a number that is out of range, the key press is ignored.)
   • When you are prompted to complete the selection, press Yes
6. If you need to perform a test print, press Copy Window to open the copy window and select the settings for the test print. Press [Start] twice, then press SP Mode (highlighted) in the copy window to return to the SP mode display.
7. When you are finished, press Exit twice to return to the copy window.