Ricoh D0BV IM600F

Overview

• The firmware is basically supplied as a package. However, an individual firmware module may be provided on special occasions, such as for correcting a problem

Each firmware module (such as System/Copy, Engine, etc.) used to be updated individually. However, an all-inclusive firmware package (package_ALL) is now available.

There are four ways to update using the firmware package.

• Removable media
  By downloading the firmware package to an SD card or USB flash drive in advance, you can update the firmware when there is no network connection.
• RFU (Remote Firmware Update)
  You can have the firmware package sent from the call center to the machine over the network for the automatic firmware update.
• SFU (Smart Firmware Update)
  Operate the machine to download the firmware package from the server, either immediately or at the programmed date and time.
• ARFU (Automatic Remote Firmware Update)
  The machine automatically checks the server for firmware packages every 76 hours. If there is a newer package than that on the machine, it will be downloaded for installation.

Firmware Update (Removable Media)

• Removable media (such as SD cards or USB flash drives) are precision devices, so when you handle them, respect the following.
• When the power is switched ON, do not insert or remove the removable media.
• During installations, do not switch the power OFF.
• Since the removable media is manufactured with high precision, do not store it in a hot or humid location, or in direct sunlight.
• Do not bend the removable media, scratch it, or give it a strong shock.
• Before downloading firmware to an SD card, check whether write-protection of the SD card is removed. If write-protection is locked, an error code (error code 44, etc.) will be displayed during download, and the download will fail.
• Before updating the firmware, disconnect network cables and interface cables, remove wireless boards, etc., (so that they are not accessed during the update).

Using the SD card for Updating

Use SD Card Slot 2 [E: Lower Slot] on the back of the machine or the SD card slot [F] on the left side of the operation panel.

• When inserting into the slot, push the SD card until it clicks.
• Check whether the card is properly in the SD card slot. When an SD card is inserted, a click is heard, and it is locked.
• To remove the card, release it by pushing it once.

To use the SD card slot [E], remove the controller cover. (Controller Cover)

Using the USB Flash Drive for Updating

Use the USB slot [A] on the left side of the operation panel.