Ricoh D0BN IMC4500

Note for Update

• When the power supply is switched OFF during firmware update, the update is interrupted, and the power is switched ON again, normal operation cannot be guaranteed.
• To guarantee operation, an update error continues to be displayed until the update is successful. In this case, insert the removable media again, switch the power ON, and continue download of firmware from the removable media automatically.
• The PS3 firmware program is included in the preinstalled PDF firmware. In the default state, although the PS3 firmware program is hidden in the disabled state, the function is enabled by installing the PS3 card. (The program installed in the PS3 card is a dongle (key) for enabling the PS3 function).
• Due to the above specification, the self-diagnosis result report shows the ROM module number /software version of the PDF firmware at the PS location.

Using the Slot on the Back of the Machine

1. Turn OFF the main power.
2. Insert the SD card into the SD card slot on the back of the machine.
3. Turn ON the main power. Wait until the update screen starts (about 30 seconds). When it appears, "Please Wait" is displayed.
4. Select the package, and then press [Execute].

   Display	Contents
   ROM:	Display installed module number/version information.
   NEW:	Display module number/version information in the card.

5. After the data waiting screen is displayed, the update is automatically started. When the firmware update is complete, "Update done" is displayed.
   - The figures at the lower right of the display indicate "Number of updated items/ All items to be updated".
6. Turning the main power OFF.
7. Remove the SD card.
8. Turn the main power ON again, and check whether the machine is operating normally.
9. Return the SD card slot cover to the original position.

Using the Slot on the Operation Panel (Immediate Update)

1. Enter the SP mode.
2. Touch [Firmware Update].
3. Touch [Media Update].
4. When the following screen is displayed, insert the removable media into the slot on the operation panel and touch [OK].
5. Touch [Execute].
6. Select the package, and then press [Execute].
7. After the data waiting screen is displayed, the update is automatically started. When the firmware update is complete, "Update done" is displayed.
   - The figures at the lower right of the display indicate "Number of updated items/ All items to be updated".
8. Turning the main power OFF.
9. Remove the removable media from the slot on the operation panel.
10. Turn the main power ON again, and check whether the machine is operating normally.

Using the Slot on the Operation Panel (Reserve)

Firmware update can be executed at the programmed date and time.

1. Enter the SP mode.
2. Touch [Firmware Update].
3. Touch [Media Update].
4. When the following screen is displayed, insert the removable media into the slot on the operation panel and touch [OK].
5. Touch [Execute].
6. Select the package, and then press [Execute].
7. Enter update date and time and specify the Retry Setting, then touch [Set].
   In "Retry setting", it is set whether or not to retry when updating cannot be started depending on the state of the machine.
8. When the following screen is displayed, pull out the removable media from the slot on the operation panel, and then touch [OK].
   Firmware update is executed at the programmed date and time.
   - Whether updating is possible or not depends on ARFU setting. However, whether to start
   pdating does not depend on SP5-886-111 (automatic update setting) setting.