Ricoh D0B2 G1027

PM Parts Replacement Procedure

1. Enter the SP mode.
2. Print the SMC logging data. (SMC Page Printing)
3. Execute the following SPs to "1".

   Item	SP No.	SP Name
   OPC Drum	SP7-622-021	PM Counter Reset	OPC
   Developer	SP7-622-024	PM Counter Reset	Developer
   Mixing Auger Bearings	SP7-622-028	PM Counter Reset	Bearing:Dev Screw
   Transfer roller	SP7-622-108	PM Counter Reset	Paper Trans Unit
   Fusing unit	SP7-622-115	PM Counter Reset	Fusing Unit
   Hot Roller Bearings	SP7-622-119	PM Counter Reset	Fusing Roll Bear

4. Exit the SP mode.
5. Turn off the main power.
6. Replace the PM parts and turn the power on. The machine will reset the PM counters.

After Installing the New PM parts

1. Turn on the main power.
2. Output the SMC logging data (SMC Page Printing) and check the counter values.
3. Make sure that the PM counters for the replaced units are "0" with SP7-621 and SP7-944.

Operation Check

Check if an example image is copied normally.