Ricoh D063 MP7001 MT-C4
Maintenance. PM Tables. Main Machine 2
Symbol key:
C: Clean, R: Replace, L: Lubricate, I: Inspect, EM: Emergency Maintenance, AN: As necessary, Exp.: Expected Life (K)
Development Unit
300K | 450K | 600K | AN | Exp. | Note | |
---|---|---|---|---|---|---|
Developer | R | PM cycle is 350K. | ||||
Development Filter | R | I | ||||
Development Roller | C | Dry cloth | ||||
Side Seals | C | C | Blower brush, dry cloth | |||
Entrance Seal | C | C | Blower brush, dry cloth | |||
Toner Hopper | C | C | Dry cloth | |||
Toner Bottle Holder | C | C | Dry cloth | |||
Toner Trap | C | C | Dry cloth | |||
Drive Gears | C | C | Blower brush. | |||
Development Roller Drive Shaft | C | C | Clean with blower brush and dry cloth every time the developer is replaced. | |||
Development Unit | C | C | Dry cloth. | |||
Paddle Roller Shaft | C | C | Blower brush, dry cloth. | |||
Used Toner Separation Unit | I | R |
Paper Feed
|
300K |
600K |
1000K |
AN |
Exp. |
Note |
---|---|---|---|---|---|---|
Registration Rollers |
C |
|
|
|
|
Alcohol |
Relay Rollers |
C |
|
|
|
|
Alcohol |
Paper Dust Mylar |
C |
|
|
C |
|
Dry cloth |
Registration Sensor |
C |
|
|
|
|
Blower brush |
Relay Sensor |
C |
|
|
|
|
Blower brush |
Bypass Paper End Sensor |
C |
|
|
|
|
Blower brush |
Grip Rollers |
C |
|
|
|
|
Dry cloth, blower brush |
Vertical Guide Plate |
C |
|
|
|
|
Dry cloth |
Paper Feed Guide Plate | C | Dry cloth | ||||
Vertical Transport Rollers | C | C | Alcohol | |||
Paper Feed Sensors | C | C | Blower brush | |||
Paper End Sensors | C | C | Blower brush | |||
Feed Rollers | R | 1000 | See Notes below this table. | |||
Pick-up Rollers | R | 1000 | ||||
Separation Rollers | R | 1000 |
Notes:
- Always replace pick-up, feed and separation rollers as a set.
- The target service life of the feed, pick-up, and separation rollers is 1000 K. However, they should be replaced sooner if the machine begins to jam or double-feed.
Transfer Belt Unit
300K | 450K | 600K | AN | Exp. | Note | |
---|---|---|---|---|---|---|
Transfer Belt | R | 750 | Use dry cloth to clean transfer belt. Always replace transfer belt and transfer roller cleaning blade together. | |||
Transfer Roller Cleaning Blade |
R | 750 | ||||
Transfer Entrance Guide Plate | C | Dry cloth | ||||
Transfer Drive Roller | C | Dry cloth | ||||
Transfer Idle Roller | C | Dry cloth | ||||
Transfer Bias Roller | C | Dry cloth | ||||
Transfer Exit Guide Plate | C | Dry cloth | ||||
Discharge Plate | R | |||||
Transfer Belt Unit Casing | C | Dry cloth | ||||
Slide Rail Bracket | C |