OKI MC562dw

The Factory-Shipping mode switching is used for switching from the Factory to Shipping mode.

1. Enter the self-diagnostic mode(Level1) and, until the following message appears, press the [2] or [8] button.
   FACTORY MODE SET
2. Press the [6] button. The following message appears. Press the [2] or [8] button until the option to set (refer to the table shown below) appears
   FACTORY MODE
   SHIPPING MODE *
3. A setting for the option can be selected by pressing the [6] button with the option on the display.
4. Press the [6] button with the setting on the display. The setting is stored in the EEPROM. The state in step 2 is restored.
5. Repeat steps 2 through 4 when necessary.
6. Press the [4] button to end the option (the state in step 1 is restored).

Option	Settings	Function
FACTORY MODE	FACTORY MODE	Establishes the Factory mode (a fuse-cut disabling mode).
	SHIPPING MODE	Deselects the Factory mode to enable the fusecut function.
FUSE INTACT Note: ****** is either INTACT or BLOWN.	BELT UNIT XXXXXX	Displays the fuse status of the transfer belt unit.
	FUSE UNIT XXXXXX	Displays the fuse status of the fuser.