OKI MC560MFP
Self-diagnostic mode. 1. How to Enter
Activation method for self-diagnostic mode (Level 1)
- The system maintenance menu mode is activated when the power is turned on with the MENU+ and MENU- keys held down simultaneously
- Press the MENU+ or MENU- key several times, until "ENGINE DIAG MODE" is displayed. Pressing the ENTER key causes "DIAGNOSTIC MODE" to appear.
- XX.XX.XX of "DIAGNOSTIC MODE XX.XX.XX" which is displayed in the LCD section is the version of the PU firmware. The set value of FACTORY WORKING MODE is indicated in the lower line to the right. Normally, S-MODE for "SHIPPING" is displayed.
- Pressing the MENU+ or MENU- key takes you to each self-diagnostic step. (The menu items rotate as the MENU+ or MENU- key is pressed.)
Deactivation of self-diagnostic mode
1. Turn the power off, and on again after ten seconds.
Maintenance Utility Adjustment Items
|
Item |
Self-diagnosis Menu |
Adjustment |
---|---|---|---|
1 |
Switch scan test |
SWITCH SCAN |
Checking of inlet sensor and switch |
2 |
Motor clutch test |
MOTOR&CLTCH TEST |
Operation test of motor and clutch |
3 |
Execution of test print |
TEST PRINT |
Print of test patterns built in PU |
4 |
Color drift correction test |
REG ADJUST TEST |
Judgment of good/bad color drift correction mechanism. |
5 |
Density correction test |
DENS ADJ TEST |
Judgment of good/bad density correction mechanism. |
6 |
Indication of consumable part counter |
CONSUMABLE STATUS |
Indication of consumed state of consumables |
7 |
Indication of consumable part continuance counter |
PRINTER STATUS |
Indication of lifetime consumed state of consumables |
8 |
Factory/ Shipping mode switching |
FACTORY MODE |
Switching between Factory mode and Shipping mode |
9 |
Check of Fuse status |
SET |
Indication of the status of each fuse |
10 |
Engine parameter setup |
SENSOR SETTING |
Setup of Enable/Disable of error detection by various sensors |
11 |
Indication of LED head serial number |
LED HEAD DATA |
Indication of the serial number of LED head data |