OKI MB280
Maintenance. REPLACING CPU BOARD, SCANNER, PRINTER
REPLACING THE CPU BOARD
To replace the terminal’s CPU board, follow this procedure:
- Print the terminal’s parameters (user, administrator and technical) and the activity counter values in order to keep a record
(▼ 5 6).
You can also store user parameters on a smart card (▼ * 6)
and restore them (▼ * 9) after the machine is serviced. - Replace the CPU board
- Launch the scanner calibration (▼ 8 0).
REPLACING THE SCANNER
To replace the scanner, follow this procedure:
- Print the terminal’s parameters (user, administrator and technical) and the activity counter values in order to keep a record
(▼ 5 6).
You can also store user parameters on a smart card (▼ * 6)
and restore them (▼ * 9) after the machine is serviced.
REPLACING THE PRINTER
To replace the printer, follow this procedure:
- Set the On/Off button to Off (position 0).
- Disconnect the USB cables and the power supply cable located at the back of the printer.
- Disassemble the consumable (it belongs to the client).
- Disassemble the printer
- Reassemble all the elements of the new printer
- Reassemble the client’s consumable.
- Reconnect the USB and power supply cable.
- Set the On/Off button to On (position I).
Remark(s) :
During repairs, it may happen that the remaining capacity indicated by the machine (▼ 8 6) does not correspond to the user’s actual toner cartridge capacity. In particular, the user may reach the end of the toner (poor quality of prints) before the remaining capacity displayed by the machine reaches 0%.