OKI ES7170MFP
Troubleshooting. 2. Abnormal operations of printer after the power is turned on 2
Abnormal sound is heard.
| Check item | Check work | Action at NG |
|---|---|---|
| Check loss of synchronization of motor (Driver error) | ||
| Operating conditions of the respective motors | Check if operations of the respective motors are normal or not by using the self-diagnostic mode. Check if any load exists or not. "Buzzer" sound when an error occurs. | Replace the PU board. |
| Condition of the motor cable | Check for normal wiring conditions of the respective motors. Perform the visual check and measure resistance at open circuit with VOM as follows. Remove the motor cable at the board end. Measure resistance between the respective pins of the removed cable and FG with VOM. |
Replace the motor cable. Re-connect the cable for normal conditions. |
| Check loss of synchronization of motor (Abnormal load of the consumable item) | ||
| Operating conditions of the respective motors | Check if operations of the respective motors are normal or not by using the self-diagnostic mode. Check if any load exists or not. "Buzzer" sound when an error occurs. | Replace the corresponding consumable item. If any attempt of using new part as a trial is going to be made, be sure to use the System Maintenance Menu FUSE KEEP MODE. |
| Check the jumping phenomena of gear tooth. (Abnormal load of the consumable item) | ||
| Operating conditions of the respective motors | Check if operations of the respective motors are normal or not by using the self-diagnostic mode. Check if any load exists or not. "Buzz buzz" sound is generated when an error occurs. | Replace the corresponding consumable item. If any attempt of using new part as a trial is going to be made, be sure to use the System Maintenance Menu FUSE KEEP MODE. |
| Installation condition of each consumable item | Check by visual inspection if the respective consumable items are installed in their normal positions in which gears of the consumable items engage accurately or not. | Replace an appropriate mechanical part as required, or adjust or repair |
| Check the wiring conditions of cables | ||
| Wiring conditions of the cables in the vicinity of the respective cooling fans | Check if the cable contacts with the fan blade because wiring conditions of the cables near fan is poor or not. "Clap, clap" sound is generated when an error occurs. | Correct the wiring conditions of the cable. |
| Check installation condition of mechanical parts | ||
| Check the installation conditions of the partition plate under the CU/PU boards | Remove the CU/PU board, and inspect the installation conditions of the partition plate by visual inspection. | If they are not hooked on the normal specified positions, correct them. |