PrintCopy.info service

OKI C612

Troubleshooting. Paper feed jam (error code 390: Multipurpose tray) 2

Jam occurs immediately after paper feed is started. (Multipurpose tray)

Check condition of the paper running path

Check item Check work Actions to be taken at NG
Paper running path of the multipurpose tray Check if paper is jammed or not in the paper running path. Remove the jammed paper.
Sheet Receive of the multipurpose tray Confirm that the Sheet Receive has moved up normally.
Confirm that the support spindle and spring of the Sheet Receive have been installed in the specified positions normally.
Correct installation of the above parts so that the Sheet Receive moves up to the specified position normally.

Check condition of the mechanical parts

Check item Check work Actions to be taken at NG
Check the sensor levers of the paper entrance sensor 2 and the WR sensor. Check if shape and movement of the sensor levers have any abnormality or not. Replace the sensor with the good sensor lever.
Planetary gear for paper feed control Rotate the paper feed motor (FRONT MOTOR) using the Motor & Clutch Test of the selfdiagnostic mode, and confirm that both of the two planetary gears rotate at the bottom position. (The planetary gear box can be located because it is the white molded block that is located on the right side when the front cover is opened.) Replace the planetary gear box
Front cover Confirm that the locks in the right and left of the front cover are locked normally. Replace the font cover assembly
Check the feed roller and the pickup roller. Check if any foreign materials such as paper dust on the surface of the feed roller or of the pickup roller or not. Remove the foreign material.
Check if the feed roller has worn out or not. Replace the feed roller.

Motor operation check

Check item Check work Actions to be taken at NG
Paper feed motor Confirm that the paper feed motor works normally by using the Motor & Clutch Test of the self-diagnostic mode. Replace the CU/PU board, or replace the paper feed motor.
Paper feed motor driver Remove the HP_PSZCL connector 9 of the CU/PU board and check the followings at the connector side.
Several MΩ between pin-1 – FG
Several MΩ between pin-2 – FG
Several MΩ between pin-3 – FG
Several MΩ between pin-4 – FG
Replace the CU/PU board.

Check the system connection

Check item Check work Actions to be taken at NG
Paper feed motor drive cable Check the connection condition of the cable.
Check if the connector is connected in the halfway only or not, and check if the connector is inserted in a slanted angle or not.
Check also that cables are assembled without any abnormality.
Replace the cable with the good cable that normalizes the connection condition.
Paper feed motor drive cable Check that any cable is not pinched during assembling of the printer.
Remove the HP_PSZCL connector 9 of the CU/ PU board and check the followings at the cable side.
Short circuit between pin-1 – FG
Short circuit between pin-2 – FG
Short circuit between pin-3 – FG
Short circuit between pin-4 – FG
Replace the cable with the good cable that normalizes the connection condition.
Paper feed motor Remove the HP_PSZCL connector 9 of the CU/ PU board and check that approx. 3.4Ω can be measured between pin-1 -pin-2, and that approx. 5Ω can be measured between pin-3 -pin-4 respectively. Replace the paper feed motor.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us