OKI C610
Maintenance Mode. Self-diagnostic mode. Level 0
Operator panel
The following description on operating the self-diagnostic is provided, premised on the following operator panel layout:
1. Self-diagnostic mode layout (Overall)
The level in a shaded area XXXXX can be displayed only from another one.
Use the MENU▲ or MENU▼ button to display the menu option shown in a non-shaded area XXXXX .
MENU▲ , MENU▼ and HELP combination used until System Maintenance menu appears, and Diagnostic Mode selected and ENTER pressed
LEVEL0- engine status display
Engine status display
(Heater temperature)
(Environmental temperature
and humidity display)
Voltage display during printing
(TR, CH, DB and SB)
Toner sensor
Error detail
MENU▲ and ONLINE held down in combination (for three sec.) ⇒
LEVEL1-ENGINE DIAG MODE XX.XX
SWITCH SCAN
MOTOR & CLUTCH TEST
TEST PRINT
REG ADJUST TEST
DENS ADJ TEST
CONSUMABLE STATUS
PRINTER STATUS
FACTORY MODE SET
SENSOR SETTING
LED HEAD DATA
MENU▼, MENU▲, ENTER and BACK pressed in combination ⇒ Normal operation mode
2. LEVEL0
Hold down the BACK or ONLINE button or momentarily press the MENU▲ or MENU▼ button to display the option shown in a shaded area XXXX .
Use the MENU▲ or MENU▼ button to display the menu option shown in a non-shaded area XXXX .
Engine status display
Heater temperature
Environmental information
Fuser, CH, DB setup table No.
TR setup table No.
TR off setup table No. , belt temperature, temperature wait time.
Side thermistor temperature