Lexmark X792
Troubleshooting. Paper jams. 202-203 Additional checks 1
Paper jam in the standard exit bin:
- Firmly grasp the paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed. - From the operator panel, touch Continue, jam cleared.
Paper jam in the fuser:
- Open the left access door.
- Open the fuser access door.
- Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed. - Close the door.
- From the operator panel, touch Continue, jam cleared.
Paper jam under the fuser:
- Open the left access door.
- If the paper is not visible, then remove the fuser unit.
- Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed. - Reinstall the fuser.
- Close the door.
- From the operator panel, touch Continue, jam cleared.
Additional checks—202–203 paper jams
Error code | Description | Action |
---|---|---|
202.01 | Exit sensor is made when printer tries to print from an idle state. Possible causes:
|
|
202.02 | Exit sensor is made early. Possible causes:
|
|
202.03 | Exit sensor is never made. Possible causes:
|
|
202.04 | Exit sensor broke early. Possible causes:
|
The fuser exit sensor may not be functioning properly. Go to “121.xx—Fuser error service check” . |
202.05, 202.07 |
Exit sensor never broke. Possible causes:
|
|
202.08 | Exit sensor is never made. | See “202.03” . |
202.31 | Bin-full sensor active when printing started. Possible causes:
|
|
202.32 | Bin-full sensor is made early. Possible causes:
|
|