Lexmark MS415

Before troubleshooting specific print problems, complete the following initial print quality check:

1. The printer must be in a location that follows the recommended operating environment specifications.
2. Check the life status of all supplies. Any supply that is low should be replaced.
3. Load 20.lb plain letter or A4 paper. Make sure the paper guides are properly set and locked. From the control panel, set the paper size and type to match the paper loaded in the tray.
4. Print a Menu settings page. Be sure to keep the original Menu settings page to restore the customer's custom settings if needed.
5. Verify on the Menu settings page if the following are set to their default values:
   • Print resolution: 600 dpi
   • Toner darkness: 8
6. Inspect the transfer roll for damage. Replace if damaged.
7. Inspect the toner cartridge and imaging unit for damage. Replace if damaged.
8. Print the Print quality pages to see if the problem remains. Use Tray 1 to test print quality problems.
9. Print a Print quality test page, and then look for variations in the print from what is expected. Verify if the settings under EP Setup are set to their default values. See “EP Defaults”.
10. Check to ensure the correct printer driver for the installed software is being used. An incorrect printer driver for the installed software can cause problems. Incorrect characters could print, and the copy may not fit the page correctly.