Lexmark MS410dn

Entering the Diagnostics menu

1. Turn off the printer.
2. Press and hold [ᐊ] and [OK].
3. Turn on the printer.
4. Release the buttons when a line of dots appears.

Registration

These settings adjust the margins of the black plane.

To set the Registration:

1. Print a Quick test page.
   a From the Diagnostics menu, navigate to:
   Registration > Quick Test
   b Retain this page to determine the changes you need to make to the margin settings. The alignment diamonds in the margins should touch the margins of the page.
   The Quick test page contains the following information:
   • Printer registration settings
   • Code levels
   • Alignment diamonds at the top, bottom, and each side
   • Horizontal lines for skew adjustment
   • General printer information, including current page count, installed memory, processor speed, serial number, engine ID, and system card ID
2. Change the value of any of the margin settings.

Top Margin	-16 to +16	Increasing the value moves the image down the page. Always adjust the top before the bottom margin.
Bottom Margin	-20 to +20	Increasing the value moves the image toward the top of the page.
Left Margin	.25 to +25	Increasing the value moves the image toward the right margin. Always adjust the left before the right margin.
Right Margin	-30 to +30	Increasing the value moves the image toward the right of the page.

Note:
The alignment of the left margin positions the black plane to the right or left. The alignment of the right margin does not alter the margins and should only be used to adjust the printhead.