Lexmark CX317dn

The Configuration menu group consists of menus, settings, and operations that are used to configure a printer for operation.

Entering the Configuration menu

1. Turn off the printer.
2. Press and hold 2 and 6 while turning on the printer.
   Release the buttons when the splash screen appears.

USB scan to local

Off: The USB device driver enumerates as a USB simple device (single interface).
On: (default) The USB device driver enumerates as a USB composite device (multiple interfaces).

Black Only Mode

This setting enables the user to force the printer to always print color content in grayscale. The printer will ignore any PJL or data stream commands that attempt to change the print mode setting. If this setting is set to off, then the printer will print color content as normal.

Print Quality Pages

The Print Quality Pages can be printed from both the Configuration Menu and the Diagnostics Menu. The Configuration Menu is limited in information compared to the pages printed from the Diagnostics Menu.

To help isolate print quality problems, print the Print Quality Test Pages. The pages are formatted. The Printing Quality Test Pages message appears, and then the pages print. The message remains on the operator panel until all the pages print.

Press Select to print the pages. The Print Quality Test Pages contain several pages. The first page, which is printed in English text only, contains a mixture of text and graphics. The information includes values of the Quality Menu settings in Settings and printer and toner cartridge configuration information. The remaining pages contain only graphics.

Fuser Cleaning Process

Over the lifetime of the device, flecks that adhere to the fuser may transfer to printed pages. The three step fuser cleaning process removes these flecks.

Values	Description
Print Cleaning Pages	The printer prints three very high-coverage, one-sided pages. Each of these pages contain instructions and information that the process heats the fuser to a very high temperature in order to loosen the flecks and make them sticky.
Start Cleaning Process	Several high-coverage sheets are fed through the fuser in order to pick up and remove the flecks.

Reports

The Reports setting contains the Menu Settings Page and Event Log.
Menu Settings Page

Print the menu settings pages to list the customer settings and to verify printer options are installed correctly. If is helpful to print the customer settings before you restore the factory defaults or make major changes.
To print the menu settings:

1. Select Reports from the Config Menu, and press Select.
2. Select Menu Settings Page, and press Select.

Event Log

The Event Log lets the system support person print a limited set of the information contained in the Diagnostic Menu version of the printed Event Log. The limited Configuration log and the full Diagnostics log printed versions show the same operator panel messages when the print and follow the same layout guidelines.

To print the Event Log:

1. Select Reports from the Config Menu, and press Select.
2. Select Print Log, and press Select to begin printing the log.