Lexmark 7529-230 CX421adn
Service menus. Service Engineer (SE) menu
Entering the Service Engineer (SE) menu
To access the Service Engineer (SE) menu:
- Turn on the printer.
- When the home screen appears, press * * 411 on the control panel.
General SE
This setting allows you to save a log file to a USB drive.
Enter the Service Engineer (SE) menu, and then navigate to:
General SE > Capture Logs to USB Drive
Network SE
| Top level menu | Intermediate menu |
|---|---|
| Print SE Menus | Print SE Menus |
| History | • Print History • Mark History |
| MAC | • Set Card Speed • LAA • Keep Alive |
| NPAP | Print Alerts |
| TCP/IP | • netstat • arp • Allow SNMP Set • MTU • Meditech Mode • RAW LPR Mode |
| Wireless | Enable Wi.Fi Direct Sigma Control Agent |
| Ping Test | • Ping • Ping6 |
| Other Actions | • ifconfig • IPtables [Firewall Dump] • IP6tables [Firewall Dump] • IPsec Dump |
Fax SE
Use this menu for the fax transmission and fax reception service checks.
Enter the Service Engineer (SE) menu, and then touch Fax SE.
Note: Use these settings as directed by the next level of support.
| Top level menu | Intermediate menu |
|---|---|
| Code Levels | • Base: [current value] • Kernel: [current value] • Network: [current value] • Engine: [current value] • Loader: [current value] • Fax: [current value] • Scanner: [current value] |
| Agency Test | • Go Off Hook • Ring Detect • Generate Tones • Modulations |
| Fax Settings | • Line Features • Fax Modulations • Detect EOLS • Print Logs • AutoPrint T30 Logs |
| Modem Settings | • Caller ID Pattern Note: Changing the value of this setting also changes the value of the Caller ID setting in the Fax Settings. • Dial Timeout • Transmit Level • Receive Thresh • DTMF Low Level • DTMF High Level • Positive Twt Ctrl • Negative Twt Ctrl • ATRA EQM Bias • V34 PreEmph Filt • Dial Tone Thresh • Progress Thresh • Pulse Make Time • Pulse Break Time • Pulse Dial Type • Interdigit Delay • Enable CEQ • V17 TX Filter • DC Characteristic • Impedance • Caller ID Pattern • Busy Tone Cycles • Busy Tone Min On Time • Busy Tone Max On Time • Busy Tone Min Off Time • Busy Tone Max Off Time • Congest Tone Cycles • Congest Tone Min On Time • Adjust Power FSK • Pulse Fall Time • High Ring Impedance |
| Reboot System | After this setting is selected, the control panel displays the message: About to reboot. Press Start to reboot. Press Stop to return. |
Scan SE
This setting displays the current left, top, right, and mag scanner registration values for each scanner source (flatbed, ADF front, ADF rear).
Enter the Service Engineer (SE) menu, and then navigate to: Scan SE > Scanner Info