Lexmark 4063-230
Service menus. Diagnostics menu. PRINTER SETUP
Defaults
Warning—Potential Damage: Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer factory settings.
| Printer default values | U.S. value | Non-U.S. value |
|---|---|---|
| Paper Sizes setting in the General Settings menu | U.S. | Metric |
| Default Paper Size (paper feeding sources which do not have hardware size sensing capabilities) | Letter | A4 |
| Default Envelope Size (envelope feeding sources which do not have hardware size sensing capability) | 10 Envelope | DL Envelope |
| Fax Paper Size | Letter | A4 |
| PCL Symbol Set | PC-8 | PC-850 |
| PPDS Code Page | 437 | 850 |
| Universal Units of Measure | Inches | Millimeters |
To change this setting:
- From the Diagnostics menu, navigate to: Printer Setup > Defaults
- Choose U.S. or Non.U.S.
- Do one of the following:
• Depending on the printer model, press OK or touch ✔ to save any changes.
• Press X to return to the Printer setup menu.
Printed Page Count
The value of this setting gauges the amount of usage on the printer. The value of the Printed Page Count setting will equal the values of the Picked Sides meter. After all print tests have been completed, the value will reset to zero.
To view the page count:
From the Diagnostics menu, navigate to PRINTER SETUP > Printed Page Count.
Note: The value of the setting cannot be changed manually.
Permanent Page Count (Perm page count)
The value of this setting indicates the total amount of pages that have been printed. After all print tests have been completed, the value will reset to zero.
To view the permanent page count:
From the Diagnostics menu, navigate to PRINTER SETUP > Perm Page Count.
Note: The Permanent Page Count value cannot be reset.
Processor ID
The value of this setting indicates the ID of the processor on the controller card within the printer.
To view the Processor ID:
From the Diagnostics menu, navigate to PRINTER SETUP > Processor ID.
Engine Setting [x]
These settings are used by the Engine code to further customize the behavior of the printer to applications. The value of [x] is any value from 1 to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area of a supported paper size). This feature does not work in PPDS emulation.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Edge to Edge.
Parallel Strobe Adjustment (Par 1 Strobe Adj)
This setting adjusts the factory setting for the amount of time the strobe is sampled to determine that valid data is available on the parallel port.
Each time the value is increased by one, the strobe is sampled 50 nanoseconds longer. Each time the value is decreased by one, the strobe is sampled 50 nanoseconds less than the default value. The range of values is between -4 and +6, in increments of one. A value of zero indicates no change is made from the factory setting.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Par 1 Strobe Adj.