Kyocera TASKalfa 6501i

Emergency-UPDATE

If Safe Update is processed to the end, the firmware update is complete. In case the message below is indicated, update the firmware after recovery with the steps below.
Note that this is unoperable when the device is operating normally.

Preparation

The USB flash device must be formatted in FAT or FAT32 in advance. Extract the main firmware to download from the file.
Rename the file which was extracted from the archive. [DL_CTRL.2N2] to [KM_EMRG.2N2]
Copy the all extracted files to the root of the USB flash device.

Procedure

1. Turn the main power switch off.
2. Insert the USB flash device in which the firmware was copied into the USB flash device slot at the left of the machine.
   
3. Turn the main power switch on.
4. Rewriting of the PWB software will start for restoration. (The LCD, memory LED, and attention LED on the operation panel will be showing the progress.)
   Caution: Never turn off the power switch or remove the USB flash device during upgrading.
5. The operation panel LCD will show “Completed” when rewriting has been finished.
   * : In case rewriting has been failed, “Error XXXX" (XXXX means an error code) will be shown.
6. Turn the main power switch off.
7. Wait for several seconds and then remove the USB flash device from the machine.
8. Insert the USB flash device in which an upgrade pack of the latest firmware or the Main/MMI/Browser and LANGUAGE BR (excluding Dictionary) were copied, into the slot on the machine and turn power on.