Kyocera TASKalfa 350ci
Troubleshooting. Mechanical problems 1
1. No primary paper feed.
Causes/check procedures | Corrective Action |
---|---|
Check if the surfaces of the following rollers are dirty with paper dust. Pickup roller Paper feed roller MP paper feed roller |
Clean with a wet cloth. |
Check if the following rollers are deformed. Pickup roller Paper feed roller MP paper feed roller |
Check and replace if deformed. |
Paper feed unit installed incorrectly. | Check and repair if necessary. |
2. No secondary paper feed.
Causes/check procedures | Corrective Action |
---|---|
Check if the surfaces of the following rollers are dirty with paper dust. Lower registration roller Lower registration roller |
Clean with a wet cloth. |
Paper conveying unit is improperly attached |
Check and repair if necessary. |
3. Skewed paper feed.
Causes/check procedures | Corrective Action |
---|---|
Paper width guide in the cassette installed incorrectly. | Check the paper width guide is attached properly and reattach or replace if necessary. |
4. Multiple sheets of paper are fed.
Causes/check procedures | Corrective Action |
---|---|
1. Check if the paper is excessively curled | Change the paper if the paper is excessively curled. |
2. The paper in the cassette is not set correctly. | Load the paper correctly. |
3. Check if the retard roller is abraded. | Replace the retard roller if it is worn. |
5. Paper jams.
Causes/check procedures | Corrective Action |
---|---|
Check if the paper is excessively curled. | Change the paper if the paper is excessively curled. |
Check if the contact between the upper and lower registration rollers is correct. | Check and repair if necessary. |
Check if the heat roller or press roller is extremely dirty or deformed. | Check and replace the fuser unit. |