Kyocera TASKalfa 3011i

13. The message requesting paper to be loaded is shown when paper is present on the cassette 1,2.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Paper sensor and engine PWB (YC14)
2. Deformed actuator of the paper sensor.	Check visually and replace if necessary.
3. Defective paper sensor.	Replace the cassette PWB.
4. Defective PWB.	Replace the engine PWB and check for correct operation

14. The message requesting paper to be loaded is shown when paper is present on the MP tray.

1. Defective connector cable or poor contact in the connector.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. MP paper sensor and engine PWB (YC15)
2. Deformed actuator of the MP paper sensor.	Check visually and replace if necessary.
3. Defective MP paper sensor.	Replace the MP paper sensor.
4. Defective PWB.	Replace the engine PWB and check for correct operation

15. The size of paper on the cassette is not displayed correctly.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Paper size width switch and engine PWB (YC14) Paper size length switch and engine PWB (YC14)
2. Defective cassette size switch.	Replace the paper size width switch or paper size length switch.
3. Defective PWB.	Replace the engine PWB and check for correct operation

16. A paper jam in the paper feed, paper conveying or eject section is indicated when the main power switch is turned on.

Causes	Check procedures/corrective measures
1. A piece of paper torn from paper is caught around registration sensor, duplex sensor , feed sensor or eject sensor.	Check visually and remove it, if any.
2. Defective sensor.	Replace the registration sensor, duplex sensor, feed sensor or eject sensor.

17. A message indicating cover open is displayed when the front cover or right cover is closed.

Causes	Check procedures/corrective measures
1. Deformed actuator of the interlock switch.	Check visually and replace if necessary.
2. Defective interlock switch.	Replace the interlock switch.
3. Defective PWB.	Replace the engine PWB and check for correct operation