Kyocera TASKalfa 2201

9. The message requesting paper to be loaded is shown when paper is present on the cassette.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Paper sensor and main/engine PWB (YC5)
2. Deformed actuator.	Check visually and replace if necessary.
3. Defective sensor.	Replace the paper sensor.
4. Defective PWB.	Replace the main/engine PWB and check for correct operation

10. The message requesting paper to be loaded is shown when paper is present on the MP tray.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. MP paper sensor and main/engine PWB (YC5)
2. Deformed actuator.	Check visually and replace if necessary.
3. Defective sensor.	Replace the MP paper sensor.
4. Defective PWB.	Replace the main/engine PWB and check for correct operation

11. The size of paper on the cassette is not displayed correctly.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Paper length switch and main/engine PWB (YC5) Paper width switch and main/engine PWB (YC5)
2. Defective switch.	Replace the paper length switch or paper width switch.
3. Defective PWB.	Replace the main/engine PWB and check for correct operation

12. A paper jam in the paper feed, paper conveying or eject section is indicated when the main power switch is turned on.

Causes	Check procedures/corrective measures
1. A piece of paper torn from paper is caught around registration sensor, fuser eject sensor	Check visually and remove it, if any.
2. Defective sensor.	Replace the registration sensor or fuser eject sensor.

13. A message indicating cover open is displayed when the front cover is closed.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Front cover switch and main/engine PWB (YC5)
2. Defective switch.	Replace the front cover switch.
3. Defective PWB.	Replace the main/engine PWB and check for correct operation

14. A message indicating unit open is displayed when the right cover is closed.

Causes	Check procedures/corrective measures
1. Defective connector cable or poor contact in the connector.	Reinsert the connector. Also check for continuity within the connector cable. If none, replace the cable. Right cover switch and main/engine PWB (YC15,YC26)
2. Defective switch.	Replace the right cover switch.