Kyocera TASKalfa 2200
Firmware. 2 Emergency Update
If the device is accidentally switched off and upgrading was incomplete, upgrade becomes impossible from a SD flash device.
In that case, retry upgrading after recovering the software by following the procedure below.
Preparation
The SD card must be formatted in FAT or FAT32 in advance.
Extract the main firmware to download from the file.
Rename the file which was extracted from the archive.
[DL_CTRL.2NG] to [KM_EMRG.2NG] : Advanced model
[DL_CTRL.2NN] to [KM_EMRG.2NN] : Basic model
Copy the all extracted files to the root of the SD card.
Procedure
- Turn the main power switch off.
- Install the SD card which contains the
firmware into the SD card slot on the machine. - Turn ON the main power switch.
- Rewriting of the PWB software will start for restoration. “Emergency Update” is displayed on the LCD of the operation panel.
- "Completed" will be displayed when rewriting is successful.
* : "Failed" will be displayed when rewriting is failed. - Turn the main power switch off.
- Wait for several seconds and then remove the SD card from the SD card slot.
- Extract the firmware to download from the archive and copy to the root of the SD flash device.
NOTE: Deletes the "ES_SKIP.on" file When it is contained directly under the SD card. - Insert the SD flash device in which the firmware was copied into the slot on the machine.
- Perform steps 3 to 7 on the previous page.
- Turn the main power switch on.
- Perform maintenance item U000 (Print a maintenance report) to check that the version of ROM U109 has been upgraded.