Kyocera TASKalfa 2200
Firmware. 1 Update
Follow the procedure to upgrade the firmware below.
- Controller Firmware
- Engine Firmware
- DP (Document Processor) Firmware
- PF (Paper Feeder) Firmware: Max 3 steps
- Option Language Data
Preparation
Extract the file that has the download firmware and store them in a SD card.
NOTE:
To improve Firmware Upgrade speed, a separate SKIP file can be added to the SD card
with the Firmware Upgrade package. The Skip file will allow ONLY the Firmware that has been
Upgraded to a New Version to load, skipping duplicate Firmware Levels.
Procedure
- Turn ON the main power switch and confirm if the screen shows “Ready to print” then, turn OFF the main power switch.
- Insert SD card that has the firmware in the SD card slot.
- Turn ON the main power switch.
- About 10 seconds later, “FW-Update” will be displayed (this shows that downloading is ready to start).
- Confirm that upgrading is completed.
- Confirm that the version of the firmware is correctly displayed.
- Turn off the main power switch by pushing it for 3 s continuously and remove the SD card.
Caution:
Never turn off the power switch or remove the SD flash device during upgrading.