Kyocera TASKalfa 181
Maintenance Mode. Item List: U100 - U260
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021
Section | Item No. | Content of maintenance item | Initial setting* |
---|---|---|---|
High voltage | U100 | Setting the main high voltage Grid control voltage Copy interval Copy quantity Correction amount |
107*1 60*1 50*1 10*1 |
U101 | Setting the other high voltages | ||
Setting the developing bias | 27/45/22/45*1 | ||
Setting the transfer voltage | 123/126/33/31*1 | ||
Setting the separation voltage | 1/20/42/2*1 | ||
U110 | Checking the drum count | - | |
Developing | U130 | Initial setting for the developing unit | - |
U144 | Setting toner loading operation | OFF/5/30*1 | |
U150 | Checking sensors for toner | - | |
U157 | Checking/clearing the developing drive time | - | |
U158 | Checking the developing count | - | |
Fuser and | U161 | Setting the fuser control temperature | |
cleaning | Primary stabilization fixing temperature | 145*1 | |
Secondary stabilization fixing temperature | 165*1 | ||
Copying operation temperature 1 | 175*1 | ||
Copying operation temperature 2 | 185*1 | ||
1*1 | |||
2*1 | |||
U162 | Stabilizing fixing forcibly | - | |
U163 | Resetting the fuser problem data | - | |
U167 | Checking/clearing the fuser counts | - | |
U198 | Setting the fuser phase control | OFF*1,*2 | |
U199 | Checking the fuser temperature | - | |
Operation panel and support equipment | U200 | Turning all LEDs on | - |
U202 | Setting the KMAS host monitoring system | - | |
U203 | Checking DP operation | - | |
U204 | Setting the presence or absence of a key card or key counter | OFF*1,*2 | |
U207 | Checking the operation panel keys | - | |
U233 | Limiting job separator output | MODE0*1 | |
U243 | Checking the operation of the DP motors | - | |
U244 | Checking the DP switches | - | |
U245 | Checking messages | - | |
U246 | Setting the finisher | 4/4/4*1 | |
U249 | Checking the paper ejection to optional devices | - | |
Mode setting | U250 | Setting the maintenance cycle | 150000*1,*2 |
U251 | Checking/clearing the maintenance count | - | |
U252 | Setting the destination | JAPAN*1 | |
U253 | Switching between double and single counts | DOUBLE COUNT (A3/LEDGER)*1,*2 | |
U254 | Turning auto start function ON/OFF | ON*1,*2 | |
U260 | Selecting the timing for copy counting | EJECT*1,*2 |