Kyocera TASKalfa 180
Maintenance Mode. Item List 2
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021
| Section | Item No. | Content of maintenance item | Initial setting* |
|---|---|---|---|
| High voltage | U100 | Setting the main high voltage Grid control voltage Copy interval Copy quantity Correction amount |
107*1 60*1 50*1 10*1 |
| U101 | Setting the other high voltages | 27/45/22/45/123/126/33/31*1 1/20/42/2*1 |
|
| U110 | Checking the drum count | - | |
| Developing | U130 | Initial setting for the developing unit | - |
| U144 | Setting toner loading operation | Off/5/30*1 | |
| U150 | Checking sensors for toner | - | |
| U157 | Checking/clearing the developing drive time | - | |
| U158 | Checking the developing count | - | |
| Fuser and | U161 | Setting the fuser control temperature | 145*1 |
| cleaning | Primary stabilization fuser temperature | ||
| Secondary stabilization fuser temperature | 165*1 | ||
| Copying operation temperature 1 | 175*1 | ||
| Copying operation temperature 2 | 185*1 | ||
| Number of sheets for fuser control | 1*1 | ||
| Number of sheets for fuser control (thick paper) | 2*1 | ||
| U162 | Stabilizing fuser forcibly | - | |
| U163 | Resetting the fuser problem data | - | |
| U167 | Checking the fuser count | - | |
| U198 | Setting the fuser phase control | Off*1,*2 | |
| U199 | Checking the fuser temperature | - | |
| Operation panel and support equipment | U200 | Turning all LEDs on | - |
| U203 | Checking DP separately | - | |
| U204 | Setting the presence or absence of a key card or key counter | Off*1 | |
| U207 | Checking the operation panel keys | - | |
| U243 | Checking the operation of the DP motors | - | |
| U244 | Checking the DP switches | - | |
| U245 | Checking messages | - | |
| Mode setting | U250 | Setting the maintenance cycle | 150000*1,*2 |
| U251 | Checking/clearing the maintenance count | 0*1,*2 | |
| U252 | Setting the destination | Japan*1 | |
| U253 | Switching between double and single counts | A3*1,*2 | |
| U254 | Turning auto start function on/off | On*1,*2 | |
| U260 | Selecting the timing for copy counting | After ejection*1,*2 | |
| U265 | Setting the destination specifications | 0*1 | |
| U277 | Setting auto application change time | 30*1,*2 | |
| U285 | Setting service status page | On*1, | |
| U286 | Setting the optional language | 0*1,*2 | |
| U332 | Setting the size conversion factor | 1.0*1,*2 | |
| U341 | Specific paper feed location setting for printing function | - | |
| U342 | Setting the ejection restriction | On*1,*2 |