Kyocera ECOSYS P6130cdn

If the part causing the problem was not supplied, use the unit including the part for replacement.

Problem	Causes/check procedures	Corrective Action
(7)The message of toner replenishing does not disappear. (K)	1. Check that the spiral of the toner container can be rotated.	Replace the toner container.
	2. Check whether the toner supply inlet opens by the lever operation.	Replace the toner container.
	Check if the roller in the developer unit rotates and the developer clutchs, etc., that transfer the drive are damaged.	1. Replace the developer unit. 2. Replace the conveying drive unit.
(8)The message of toner replenishing does not disappear. (C,M,Y)	1. Check that the spiral of the toner container can be rotated.	Replace the toner container.
	2. Check whether the toner supply inlet opens by the lever operation.	Replace the toner container.
	Check if the roller in the developer unit rotates and the couplings, etc., that transfer the drive are damaged.	1. Replace the developer unit. 2. Replace the main drive unit.
(9) Abnormal sound is generated.	Check if the rollers, pullys and gears rotate smoothly.	Grease the bushes and gears.
	Check if the roller in the developer unit rotates.	If the developer roller is locked, replace the developer unit.
	Check if the problem has occured between the cleaning section in the primary transfer unit and the drive transmission section of the main unit.	1. If the waste toner is clogged inside the cleaning unit, clean it.
		2. If it is the sliding noise from the side of the waste joint gear in the main body, grease the gear.
	Check the occurrence from the fuser unit. During printing drive, or at the power is turned on, the fuser motor is rotated reversely for the pressure releasing operation.	Check if the meshing of gears is proper, and if necessary, reattach the fuser unit. Grease the fuser release drive gear.
	Check if it occurrs when the cassette lift motor operates.	Check if the cassette lift motor is attached properly, and if necessary, reattach it.