Kyocera ECOSYS P6130cdn

If the part causing the problem was not supplied, use the unit including the part for replacement.

Problem	Causes/check procedures	Corrective Action
(1) No primary paper feed.	Check if the surfaces of the following rollers are dirty with paper dust. Pickup roller Paper feed roller MP paper feed roller	Clean with a wet cloth.
	Check if the following rollers are deformed. Pickup roller Paper feed roller MP paper feed roller	Check and replace if deformed.(see page
	Paper feed unit installed incorrectly.	Check and repair if necessary.
(2) No secondary paper feed.	Check if the surfaces of the following rollers are dirty with paper dust. Lower registration roller Lower registration roller	Clean with a wet cloth.
	Paper conveying unit is improperly attached	Check and repair if necessary.
(3) Skewed paper feed.	Paper width guide in the cassette installed incorrectly.	Check the paper width guide is attached properly and reattach or replace if necessary.
(4) Multiple sheets of paper are fed.	1. Check if the paper is excessively curled.	Change the paper if the paper is excessively curled.
	2. The paper in the cassette is not set correctly.	Load the paper correctly.
	3. Check if the retard roller is abraded.	Replace the retard roller if it is worn.
(5) Paper jams.	Check if the paper is excessively curled.	Change the paper if the paper is excessively curled.
	Check if the contact between the upper and lower registration rollers is correct.	Check and repair if necessary.
	Check if the heat roller or press roller is extremely dirty or deformed.	Check and replace the fuser unit.
(6) Toner drops on the paper conveying path.	Check if the developer unit, drum unit, and primary transfer unit is extremely dirty.	Clean the developer unit, drum unit, and primary transfer unit.