Kyocera ECOSYS P6130cdn
Troubleshooting. Electric problems 4
If the part causing the problem was not supplied, use the unit including the part for replacement. Troubleshooting each failure must be in the order of the numbered symptoms.
Problem | Causes | Check procedures/corrective measures |
---|---|---|
(15) The size of paper on the MP tray is not displayed correctly. | 1. Defective connector cable or poor contact in the connector | Reinsert the connector. Also check the continuity within the connector wire. If none, replace the wire. Cassette size detection switch and Engine relay PWB (YC5) |
2. Defective switch. | Replace the cassette size detection switch. | |
3. Defective PWB. | Replace the engine relay PWB. | |
(16) A paper jam in the paper feed, paper conveying or eject section is indicated when the power switch is turned on. | 1. Defective connector cable or poor contact in the connector | Reinsert the connector. Also check the continuity within the connector wire. If none, replace the wire. Registration sensor and Main/Engine PWB (YC12) Eject sensor, Eject full sensor and Main/Engine PWB (YC11) |
2. A piece of paper torn from paper is caught around PF paper feed sensor, eject sensor or paper full sensor. | Check and remove torn paper if any. | |
3. Defective sensor. | Replace the registration sensor, PF paper feed sensor, paper full sensor or eject sensor. | |
4. Defective PWB. | Replace the engine relay PWB. | |
Replace the Main/Engine PWB. | ||
(17) A message indicating cover open is displayed when the rear cover is closed. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Interlock switch and Power source PWB (YC104) |
2. Defective switch. | Check the interlock switch, and if necessary, replace it. | |
3. Defective PWB. | Replace the power source PWB. |