Kyocera ECOSYS P6130cdn

If the part causing the problem was not supplied, use the unit including the part for replacement. Troubleshooting each failure must be in the order of the numbered symptoms.

Problem	Causes	Check procedures/corrective measures
(10) Developer clutch does not operate.	1. Defective connector cable or poor contact in the connector	Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Developer clutch and Engine relay PWB (YC15) Engine relay PWB (YC1) and Main/Engine PWB (YC4)
	2. Defective clutch.	Replace the conveying drive unit.
	3. Defective PWB.	Replace the engine relay PWB.
		Replace the Main/Engine PWB.
(11) Middle clutch does not operate.	1. Defective connector cable or poor contact in the connector	Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Paper feed clutch and Engine relay PWB (YC15) Engine relay PWB (YC1) and Main/Engine PWB (YC4)
	2. Defective clutch.	Replace the conveying drive unit.
	3. Defective PWB.	Replace the engine relay PWB
		Replace the Main/Engine PWB.
(12) MP solenoid does not operate.	1. Defective connector cable or poor contact in the connector	Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. MP solenoid and Engine relay PWB (YC16) Engine relay PWB (YC1) and Main/Engine PWB (YC4)
	2. Defective the solenoid.	Replace the MP solenoid.
	3. Defective PWB.	Replace the engine relay PWB.
		Replace the Main/Engine PWB.
(13) The message requesting paper to be loaded is shown when paper is present on the cassette.	1. Defective connector cable or poor contact in the connector	Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Cassette PWB and Engine relay PWB (YC8)
	2. Deformed actuator.	Check and replace if necessary.
	3. Defective sensor.	Replace the cassette PWB.
	4. Defective PWB.	Replace the engine relay PWB.
(14) The message requesting paper to be loaded is shown when paper is present on the MP tray.	1. Defective connector cable or poor contact in the connector	Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. MP paper sensor and Engine relay PWB (YC18)
	2. Deformed actuator.	Check and replace if necessary.
	3. Defective sensor.	Replace theMP paper sensor.
	4. Defective PWB.	Replace the engine relay PWB.