Kyocera ECOSYS P6130cdn
Troubleshooting. Electric problems 2
If the part causing the problem was not supplied, use the unit including the part for replacement. Troubleshooting each failure must be in the order of the numbered symptoms.
| Problem | Causes | Check procedures/corrective measures |
|---|---|---|
| (5) LSU fan motor does not operate. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. LSU fan motor and Engine relay PWB (YC23,24) Engine relay PWB (YC1) and Main/Engine PWB (YC4) |
| 2. Defective motor. | Replace the LSU fan motor. | |
| 3. Defective PWB. | Replace the engine relay PWB. | |
| Replace the Main/Engine PWB. | ||
| (6) Container fan motor does not operate. | 1. Defective connector cable or poor contact in the connector | Reinsert the connector. Also check the continuity within the connector wire. If none, replace the wire. Container fan motor and engine relay PWB (YC24) |
| 2. Defective motor. | Replace the container fan motor. | |
| 3. Defective PWB. | Replace the Main/Engine PWB. | |
| (7) Paper feed clutch does not operate. | 1. Defective connector cable or poor contact in the connector | Reinsert the connector. Also check the continuity within the connector wire. If none, replace the wire. Paper feed clutch and Engine relay PWB (YC15) Engine relay PWB (YC1) and Main/Engine PWB (YC4) |
| 2. Defective clutch. | Replace the conveying drive unit. | |
| 3. Defective PWB. | Replace the engine relay PWB. | |
| Replace the Main/Engine PWB. | ||
| (8) Registration clutch does not operate. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Registration clutch and Main/Engine PWB (YC21) |
| 2. Defective clutch. | Replace the conveying drive unit. | |
| 3. Defective PWB. | Replace the Main/Engine PWB | |
| (9) Duplex clutch does not operate. (35/40 ppm printer model only) | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Duplex clutch and Engine relay PWB (YC15) Engine relay PWB (YC1) and Main/Engine PWB (YC4) |
| 2. Defective clutch. | Replace the conveying drive unit. | |
| 3. Defective PWB. | Replace the Main/Engine PWB. |