Kyocera ECOSYS P6130cdn
Troubleshooting. Electric problems 1
If the part causing the problem was not supplied, use the unit including the part for replacement. Troubleshooting each failure must be in the order of the numbered symptoms.
| Problem | Causes | Check procedures/corrective measures |
|---|---|---|
| (1)The machine does not operate when the power switch is turned on. | 1. No electricity at the power outlet. | Measure the input voltage. |
| 2. The power cord is not plugged improperly. | Check the connection of the connectors. | |
| 3. Broken power cord. | Check for continuity. If none, replace the wire. | |
| 4. Defective power switch. | Checkcontinuity across the contacts. If none, replae the power switch. | |
| 5. Defective power source PWB. | Replace the power source PWB. | |
| 6. Defective Engine relay PWB. | Replace the engine relay PWB. | |
| 7. Defective Main/ Engine PWB. | Replace the Main/Engine PWB and check operation. | |
| (2) Duplex eject motor does not operate. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Duplex eject motor and Engine relay PWB (YC20) Engine relay PWB (YC1) and Main/Engine PWB (YC4) |
| 2. Defective drive transmission system. | Check if the rollers and gears rotate smoothly. If not, clean or grease the bushes and gears. Check broken gears and replace if any. | |
| 3. Defective motor. | Reattach the duplex eject motor. Or replace. | |
| 4. Defective PWB. | Replace the engine relay PWB. | |
| Replace the Main/Engine PWB. | ||
| (3) Toner motor does not operate. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Toner motor and Engine relay PWB (YC18) Engine relay PWB (YC4) and Main/Engine PWB (YC1) |
| 2. Defective motor. | Reattach the toner motor. Or replace. | |
| 3. Defective PWB. | Replace the engine relay PWB. | |
| Replace the Main/Engine PWB. | ||
| (4) Power source fan motor does not rotate. | 1. Defective connector cable or poor contact in the connector | Reconnect the connector if its connection is loose. Also check the continuity within the connector wire. If none, replace the wire. Power source fan motor and Main/Engine PWB (YC19) |
| 2. Defective motor. | Replace the power source fan motor. | |
| 3. Defective PWB. | Replace the Main/Engine PWB. |