Kyocera ECOSYS P3145dn
Troubleshooting. Jam. Corrective Actions: J1413 - J421X
| Jam types | Check description | Corrective measures |
|---|---|---|
| PF conveying sensor stay jam (J1413, J1414, J1415, J1614, J1615, J1815) | 1 Check to see if the actuator is operative without hinderance. | If it won't operate without hinderance, re-assemble or replace the actuator's return spring. |
| 2 Check the operation of the sensor. | If the sensor is inoperative, replace. | |
| 3 Check if the PF paper feed clutch rotates following the other component. | If stained, replace the clutch.Re-assmeble the clutch so that it is not continuously energized. (Change of wirings, etc.) | |
| 4 Check if the conveying guide is twisted to be mounted.(If the mounting parts of the guide is floated, the actuator won't protrude sufficiently.) | If the bracket is twisted to be mounted, remove the screw fixing the conveying guide and properly mount the bracket in the right position and fix again. | |
| 5 Check no wrinkles are observed at the sluck of paper during paper feeding. | Adjust the cursors to the size of the paper. | |
| PF conveying sensor non arrival jam (J1403/J1404, J1405, J1604, J1605, J1805) | 1 Check to see if the actuator is operative without hinderance. | Re-assemble or replace the actuator's return spring. |
| 2 Check the operation of the motor. Check the transmission of the gear drive . * : Check the conveying roller rotates and is movable in the direction of thrust without hinderance. |
If the roller won't rotate without hinderance, loosen the screws for adjusting the position (at the gear train bracket) to mount the driving gears, and tighten so that a gap between the gears and frame is eliminated. | |
| Fuser eject sensor stay jam (J421X) | 1 If paper jam occurrs at the feedshift guide in the rear cover assembly, check if the guide is operative without hinderance. | If the distance between the housing and the feedshift guide is too small for the guide to move without hinderance, replace the rear cover assembly. |
| 2 Check if the eject sensor does not show a false detection. | Replace the defective eject sensor or the fuserunit. |