Kyocera ECOSYS M6535cidn
Troubleshooting. Jam. Corrective Actions: J0508 - J1604
| Jam types | Check description | Corrective Action |
|---|---|---|
| Duplex no paper feeding Jam (J0508) Duplex Multiple-feed Jam (J0518) | Check if the registration sensor is detected. | If the registration sensor is not working, replace the registration sensor. |
| PF conveying sensor stay jam (J1413, J1414, J1614) | 1. Check to see if the actuator of the paper conveying sensor is smoothly operative. | If it does not operate smoothly, reattach or replace the actuator's return spring. |
| 2. Check the operation of the sensor. | If the sensor is inoperative, replace it. | |
| 3. Check if the PF paper feed clutch rotates following other component. | If stained, replace the clutch. Re-assmeble the clutch so that it is not continuously energized. Change of wirings, etc. | |
| 4. Check if the conveying guide is attached while twisted. (If the attached parts of the guide is floated, the actuator does not protrude sufficiently.) | If the bracket is attached while twisted, remove the screw securing the conveying guide and properly reattach the bracket in the right positioning. | |
| 5. Check no wrinkles are observed at the sluck of paper during paper feeding. | Adjust the cursors to the size of the paper. | |
| PF conveying sensor non arrival jam (J1403, J1404, J1604) | 1. Check to see if the actuator is smoothly operative. | Reattach or replace the actuator's return spring. |
| 2. Check the operation of the motor. Check the transmission of the gear drive by the clutch operation. *: * Check the conveying roller rotates and is smoothly movable in the thrust direction. | If the roller does not rotate smoothly, loosen the screws for adjusting the position (at the gear train bracket) to mount the driving gears, and tighten so that a gap between the gears and frame is eliminated. | |
| Fuser eject sensor non arrival jam, stay jam (J420X,J421X) | 1. If paper jams at the feedshift guide, check if the guide is smoothly operative. | If the clearance between the housing and the feedshift guide is too small for the guide to smoothly move, replace the feedshift guide. |
| 2. Check to see if the actuator of the ejct sensor is smoothly operative. | 1. If the actuator is not in proper position, or does not return due to falling of the return spring, reattach it. 2. If the actuator is damaged or deformed, replace it. |
|
| 3. Check if the eject sensor does not show a false detection. | Replace the defective eject sensor or the eject unit. |