| Section |
No. |
Content of maintenance item |
Outline |
| General |
U000 |
Output Maintenance Report |
Printing the reports and exporting them to a USB Flash Drive |
| U001 |
Exit Maintenance Mode (Mes- sage: Exit Mainte) |
Canceling the maintenance mode |
| U002 |
Set Factory Default (Message: Set Factory Def) |
Initializing to the factory-default setting |
| U004 |
Machine Number (Message: Machine No.) |
Display of the machine serial number and set- ting |
| U010 |
Set Maintenance Mode ID (Mes- sage: Set Mainte ID) |
Setting the maintenance mode ID |
| U019 |
Firmware Version (Message: Firm Version) |
Display of each PWB's firmware version |
| Initializa- tion |
U021 |
Initialize Memory (Message: Init Memory) |
Initializing the backup RAM |
| U025 |
Firmware Update(Security) (Mes- sage: Firm Update(S)) |
Update of the firmware |
| Drive, paper feed, paper convey- ing and cooling system |
U034 |
Adj Paper Timing (Message: Adj Paper Timing) |
Adjusting the leading edge timing and the center line |
| Optical |
U065 |
Scanner Adjust (Message: Adj Scn) |
Adjusting the magnification for table scanning |
| U066 |
Table Timing (Message: Table Timing) |
Adjusting the leading edge timing for table scan- ning |
| U067 |
Table Center (Message: Table Center) |
Adjusting the center line for table scanning |
| U068 |
DP Scn Start Pos (Message: DP Scn Start Pos) |
Adjusting the starting position for DP-scanning |
| U070 |
Adjust DP Motor Speed (Mes- sage: Adj DP Motor) |
Adjusting the magnification for DP-scanning |
| U071 |
Adjust DP Leading Edge Timing (Message: DP Timing) |
Adjusting the leading edge timing for DP-scan- ning |
| U072 |
Adjust DP Original Center (Mes- sage: DP Center) |
Adjusting the center line for DP-scanning |
| Transfer |
U127 |
Checking/clearing the transfer counts |
Display of the maintenance counts |
| Fuser |
U167 |
Clear Fuser Counter (Message: Clr Fuser Cnt) |
Display of the maintenance counts and Check- ing/clearing |