Section |
No. |
Maintenance item |
Outline |
General |
U000 |
Printing Maintenance Report |
Printing the reports and exporting them to a USB memory |
U001 |
Exiting the maintenance mode |
Exiting from the maintenance mode |
U002 |
Set Factory Default |
Initializing to the factory-default setting |
U004 |
Machine serial number |
Display of the machine serial number and set- ting |
U010 |
Setting the maintenance mode ID |
Setting the maintenance mode ID |
U019 |
Firmware Version |
Displays the firmware version of the PWB |
Initializa- tion |
U021 |
Initializes Memory |
Initializing the backup RAM |
U025 |
Firmware update (S) |
Updates the firmware |
Drive Paper feed Convey- ing Cooling |
U034 |
Paper timing adjustment |
Adjusting the leading edge timing and the center line |
Optical |
U065 |
Adjusting the magnification for table scanning |
Adjusting the magnification for table scanning |
U066 |
Adjusting the table scanning timing |
Adjusting the leading edge timing for table scan- ning |
U067 |
Adjusting the table scanning center line |
Adjusting the center line for table scanning |
U068 |
DP scanning position adjustment |
Adjusting the starting position for DP scanning |
U070 |
DP magnification adjustment |
Adjusting the magnification for DP scanning |
U071 |
Adjusting the DP leading edge Tim- ing |
Adjusting the DP scanning timing |
U072 |
Adjusting the DP original center |
Adjusting the center line for DP scanning |
High volt- age sys- tem |
U127 |
Clearing the transfer count |
Displaying the counts |
Fuser |
U199 |
Fuser temperature |
Monitor the fuser temperature |
Opera- tion sec- tion / Support equip- ment |
U201 |
Initializing the touch panel |
Correct the X and Y axis position of the touch panel |
U222 |
Setting the IC card type |
Sets the ID card type |
Mode Setting |
U252 |
Destination |
Sets the machine operation and indication depending on the specification of the destination |
U253 |
Switching the double/single counts |
Sets the counter by color mode |
U260 |
Select Copy Count |
Setting the count-up timing |
U285 |
Set Service Status Page |
Setting the print coverage report output |