Kyocera ECOSYS M3860idn
Maintenance Mode. Modes List: U000 - U271
Section | No. | Maintenance item | Outline |
---|---|---|---|
General | U000 | Printing Maintenance Report | Printing the reports and exporting them to a USB memory |
U001 | Exit Mainte | Exiting from the maintenance mode | |
U002 | Set Factory Def | Restore machine to shipping status | |
U004 | Machine Number | Display of the machine serial number and setting | |
U010 | Set Mainte ID | Setting the maintenance mode ID | |
U019 | Firm Version | Displays the firmware version of the PWB | |
Initialization | U021 | Init memory | Initializing the backup RAM |
U025 | Firm Update(S) | Updates the firmware | |
Drive Paper feed Conveying Cooling | U034 | Adj Paper Timing | Adjusting the leading edge timing and the center line |
U037 | Fan motor operation check | Drive each fan motor. | |
Optical | U065 | Adj Scn | Adjusting the magnification for table scanning |
U066 | Table Timing | Adjusting the leading edge timing for table scanning | |
U067 | Table Center | Adjusting the center line for table scanning | |
U068 | DP Scn Start Pos | Adjusting the starting position for DP scanning | |
U070 | Adj DP Motor | Adjusting the magnification for DP scanning | |
U071 | DP Timing | Adjusting the DP scanning timing | |
U072 | DP Center | Adjusting the center line for DP scanning | |
U089 | Output MIP-PG | Performs output of MIP-PG Pattern. | |
U091 | Set White Line Correction | Set the white lines detection threshold | |
High voltage system | U110 | Drum counter | Displays/sets the drum counter |
U111 | Drum drive time | Display the drum drive time that is used for the high-voltage time correction | |
U117 | Drum unit number | Displays the drum number | |
Developer system | U130 | Set Toner Install | Installation of a toner is performed. |
U135 | Checking the toner motor operation | Drive the toner motor | |
U136 | Toner level detection setting | Sets the number of pages printable at toner near end | |
U147 | Set Toner Apply | Sets the overcharge toner removal mode | |
U157 | Developer drive time | Displays/sets the developer drive time | |
U158 | Developer counter | Displays/sets the developer counter | |
Fuser | U198 | Fuser phase control setting | Switch the stationary phase control |
Operation section / Support equipment |
U201 | Init Touch Panel | Correct the X and Y axis position of the touch panel |
U203 | Chk DP Ope | Checking the DP paper conveying operation with the DP alone | |
U207 | Chk Panel Key | (For HyPAS model) Check the operation panel key operation | |
U207 | Chk Panel Key | (For Basic model) Check the operation panel key operation | |
U222 | Set IC Card Type | Sets the ID card type | |
U246 | Adj Fin | Set finisher adjustment value. | |
Mode Setting | U250 | Mnt Cnt Pre-set | Changes the preset value |
U251 | Clr Mnt Cnt | Displaying/clearing/changing the counter value | |
U252 | Set Dest | Sets the machine operation and indication depending on the specification of the destination | |
U253 | Sel D/S Count | Sets the counter by color mode | |
U260 | Set Count Mode | Setting the count-up timing | |
U265 | Set Model Dest | Sets the OEM code | |
U271 |
Setting the page count unit |
Set the counting unit of the long size paper |