Kyocera ECOSYS M3040idn
Maintenance Mode. Modes List: U600 - U632
Section | Item No. | Content of maintenance item | Summary |
---|---|---|---|
FAX | U600 | Init All Data | According to the country code and the OEM code which were inputted, all the softswitches, backup data, and an image memory are initialized. |
U601 | Init Keep Data | Softswitches other than machine data are initialized according to the country code and the OEM code which were inputted. | |
U603 | User Data 1 | A circuit class is set up. | |
U604 | User Data 2 | The number of times of a bell at the time of a FAX/TEL automatic change is set up. | |
U605 | Clr Data | All the data of a communication history and a protocol list is cleared. | |
U610 | System Setting 1 | The number of waste lines at the time of degree, the number of waste lines at the time of automatic reduction, and the num- ber of waste lines at the time of automatic reduction (A4, LETTER) are set up. | |
U611 | System Setting 2 | The number of adjustment lines at the time of automatic reduction and the number of adjustment lines at the time of automatic reduction (A4, LETTER) are set up. | |
U612 | System Setting 3 | An automatic reduction setup at the time of receiving a long manuscript is carried out. The automatic output of a protocol list is set up. | |
U620 | FAX System | Remote change mode (a continued type / one shot type) is set up. | |
U625 | Set Comm | The interval of a redial and the number of times are set up. | |
U630 | Comm Ctrl 1 | Transmitting start speed and receiving abil- ity speed are set up. The measure against an echo at the time of transmission/reception is set up. |
|
U631 | Comm Ctrl 2 | It is set up whether transmission and reception can be performed in ECM. The frequency of CED is set up. | |
U632 | Comm Ctrl 3 | It is set up whether sending out after bit33 of a DIS/DTC signal is performed. The number of times of CNG detection at the time of a FAX/TEL automatic change is set up. |