Section |
Item No. |
Content of maintenance item |
Summary |
General |
U000 |
Mainte Report |
It outputs to printing of each report, and USB. |
U001 |
Exit Mainte |
Maintenance mode is canceled. |
U002 |
Set Factory Def |
A factory-shipments setup (initialization) and packing mode are set up. |
U004 |
Machine No. |
The display of machine serial No. and serial No. acquired from the engine at the time of substrate exchange are copied to MAIN backup. |
U010 |
Set Mainte ID |
The brittleness of a security function is pre- vented by changing ID. |
U019 |
Firm Version |
Each soft version is displayed. |
Initializa- tion |
U021 |
Init memory |
The backup data except an adjustment value is initialized. |
U025 |
Firm Update(S) |
Only an administrator can be made to do FW-UPDATE. |
Drive, paper feed and paper conveying system |
U034 |
Adj Paper Timing |
The timing data of leading edge and the center line adjustment data in a paper stan- dard are set up. |
Optical |
U065 |
Adj Scn |
The degrees of the main and auxiliary scanning direction at the time of table read- ing are adjusted. |
U066 |
Table Timing |
The timing of leading edge and trailing edge at the time of table reading are adjusted. |
U067 |
Table Center |
The position of main scanning direction at the time of table reading are adjusted. |
U068 |
DP Scn Start Pos |
The timing of starting position at the time of DP reading are adjusted. |
U070 |
Adj DP Motor |
The degree of auxiliary scanning direction are adjusted by adjusting the speed of time of DP reading. |
U071 |
DP Timing |
The timing of DP reading are adjusted. |
U072 |
DP Center |
The center line of DP reading image are adjusted. |
Developer |
U130 |
Set Toner Install |
Installation of a toner is performed. |
U147 |
Set Toner Apply |
Same as the above |