| Section |
No. |
Maintenance item |
Outline |
| General |
U000 |
Printing Maintenance Report |
Printing the reports and exporting them to a USB memory |
| U001 |
Exiting the maintenance mode |
Exiting from the maintenance mode |
| U002 |
Set Factory Default |
Initializing to the factory-default setting |
| U004 |
Machine number |
Display of the machine serial number and set- ting |
| U010 |
Setting the maintenance mode ID |
Setting the maintenance mode ID |
| U019 |
Firmware Version |
Displays the firmware version of the PWB |
| Initializa- tion |
U021 |
Initializes Memory |
Initializing the backup RAM |
| U025 |
Firmware update (S) |
Updates the firmware |
| Drive Paper feed Convey- ing Cooling |
U034 |
Paper timing adjustment |
Adjusting the leading edge timing and the center line |
| Optical |
U065 |
Adjusting the magnification for table scanning |
Adjusting the magnification for table scanning |
| U066 |
Adjusting the table scanning timing |
Adjusting the leading edge timing for table scan- ning |
| U067 |
Adjusting the table scanning center line |
Adjusting the center line for table scanning |
| U068 |
DP scanning position adjustment |
Adjusting the starting position for DP scanning |
| U070 |
DP magnification adjustment |
Adjusting the magnification for DP scanning |
| U071 |
Adjusting the DP leading edge Tim- ing |
Adjusting the DP scanning timing |
| U072 |
Adjusting the DP original center |
Adjusting the center line for DP scanning |
| High voltage system |
U110 |
Drum counter |
Displays/cleas the drum counter |
| U120 |
Drum counter |
Displays/clears the drum driveing distance counter |
| Developer system |
U130 |
Developer initial setting |
Set the toner install mode on or off. |
| U158 |
Developer counter |
Displays/sets the developer counter |
| Operation section / Support equip- ment |
U201 |
Initializing the touch panel |
Correct the X and Y axis position of the touch panel |
| U222 |
Setting the IC card type |
Sets the ID card type |