Konica-Minolta bizhub C7822
Troubleshooting. Jam Code: 11-01, 11-02, 11-40
Contents
JAM type | Misfeed at tray 1 feed section |
JAM code | 11-01, 11-02, 11-40 |
Detection timing | 11-01 The leading edge of the paper does not unblocked the registration sensor (PS1) even after the lapse of a given period of time after the tray 1 starts to feed paper. |
11-02 For paper fed from the tray1, due to a delay in paper arrival, loop forming in front of the registration roller is not complete before the rise timing of the transport motor (M1). |
|
11-40 For paper fed from the tray1, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. |
|
Tray 1 paper feed sensor (PS23) is turned ON when the main power switch is turned ON, a door or cover is opened and closed, or a misfeed or malfunction is reset. (bizhub C364/C284 only) | |
In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at tray 1 feed section | |
Misfeed processing location | • Right door • Tray 1 |
Relevant parts | • Transport motor (M1) • Tray 1 paper feed clutch (CL3) • Registration clutch (CL4) • Registration sensor (PS1) • Tray 1 paper feed sensor (PS23) • Front side board (FRB) • Printer control board (PRCB) |
Procedure
Step | Action | Control signal | Location |
---|---|---|---|
1 | Initial check items | ||
2 | PS1 I/O check, sensor check | FRB CN8-3 (ON) | 4 to 5-L |
3 | PS23 I/O check, sensor check (bizhub C364/C284 only) | PRCB CN26-10 (ON) | bizhub C364/C284 8-C |
4 | CL3 operation check | PRCB CN26-8 (ON) | 8-C |
5 | CL4 operation check | FRB CN8-7 (CL4_24V) | 4-L |
6 | M1 operation check | PRCB CN31-2 (REM) PRCB CN31-5 (LOCK) |
bizhub C364 21-J bizhub C284 22-J bizhub C224 24-J |
7 | PRCB ICP5 conduction check | ||
8 | Replace FRB | ||
9 | Replace PRCB |