Konica-Minolta bizhub C654e
Troubleshooting. Jam Code: 10-01, 10-02, 10-40
Contents
| JAM type | Misfeed at manual bypass feed section |
| JAM code | 10-01, 10-02, 10-40 |
| JAM code 10-01, 10-02, 10-40 Detection timing | 10-01 The leading edge of the paper does not unblocked the registration (PS1) even after the lapse of a given period of time after the manual bypass starts to feed paper. |
| 10-02 For paper fed from the manual bypass, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. |
|
| 10-40 For paper fed from the manual bypass, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. |
|
| In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at manual bypass feed section. | |
| Misfeed processing location | Right door |
| Relevant parts | • Paper feed motor (M22) • Registration motor (M24) • Bypass paper feed clutch (CL7) • Bypass pick-up solenoid (SD1) • Registration sensor (PS1) • Front side board (FRB) • Expansion control board (EXCB) • Printer control board (PRCB) |
Procedure
| Step | Action | Control signal | Location |
|---|---|---|---|
| 1 | Initial check items | ||
| 2 | PS1 I/O check, sensor check | FRB CN8-3 (ON) | 3-L |
| 3 | CL7 operation check | PRCB CN27-8 (ON) | 3-C |
| 4 | SD1 operation check | PRCB CN27-10 (ON) | 4-C |
| 5 | M22 operation check | EXCB CN3-5 to 8 | 22-P |
| 6 | M24 operation check | EXCB CN3-1 to 4 | 21-P |
| 7 | Replace FRB | ||
| 8 | Replace EXCB | ||
| 9 | PRCB ICP5 conduction check | ||
| 10 | Replace PRCB |