Konica-Minolta bizhub C3320i

Starting the update screen

NOTE

• When [Administrator] -> [Security] -> [USB port connection permission] -> [USB flash drive] -> [Firmware Update Parameters] is set to "Restrict", firmware update cannot be executed by using a USB memory.
• When the main power switch is turned on, a message "It is limited by the administrator." will appear.
• When [Administrator] -> [Security] -> [Firmware Update (USB) Permission Setting] is set to "Password Priority", it requires to input a password after confirming with the administrator.
• USB memory must be connected with the main power switch off.

Procedure

1. Turn OFF the main power switch.
2. Connect the USB memory containing the firmware into the USB port on the right side of the control panel.
3. Turn the main power switch ON while pressing the Stop key.
4. Firmware Update selection screen is displayed.

NOTE

• Unless one of the keys on the control panel is pressed, firmware is automatically updated after 30 seconds when the main power switch is turned on.
• Selectable items displayed change depending on equipped options, etc.

Selecting the firmware data

• When multiple set of firmware data is stored in the USB memory, a set of data can be selected.
• The firmware data in the update data folder "FW0023" copied to the root directory of the USB memory is selected as the default data.

Procedure

1. Touch [FW Data Select] on the firmware update selection screen.
2. After the data in the USB memory is checked, a list of the available firmware data is displayed.
   • The default data is indicated by an asterisk (*).
3. Select the firmware, and touch [OK].

Language Selection

• Select the language data displayed on the Language Selection screen of Utility.
• Select languages as required according to, for example, the use environment of the user.

NOTE:
Up to 9 languages are selectable. However, Japanese and English are essential options.

Procedure

1. Touch [Language Select] on the firmware update selection screen.
2. On the Language Select screen, select a language to be displayed on the LCD area of the control panel, then touch [Fix].
3. Touch [OK].

Updating the firmware

1. Select the target firmware data to be updated in the Firmware Update selection screen. If multiple pages is displayed in the selection screen, check all of the pages.
2. Press the [START]. (At this time, the Power key LED starts blinking red.)
   NOTE
   ▪ The progress ratio of each board is displayed in writing the program.
3. Check that the control panel shows the message indicating that the data has been rewritten correctly ([Downloading Completed]). (The
   Power key LED lights blue.)
   NOTE
   ▪ Check all pages, and make sure that no item is under firmware updating (Downloading...).
4. Turn OFF the main power switch.
5. Remove the USB memory.
6. Turn ON the main power switch.
7. Check the firmware version in Service Mode.