Konica-Minolta bizhub C200
Troubleshooting. Jam 02. Solution when paper curl occurs
| Step | Check items/actions | ||
|---|---|---|---|
| 1 | Turn over the stacked paper in the paper tray. | OK | — |
| NG | Go to step 2. | ||
| 2 | Does paper curl occur just after a warm-up has been completed or the sleep mode has been turned OFF? | YES | Go to step 3. |
| Does paper curl occur under normal conditions (under conditions other than those mentioned above)? | YES | Go to step 5. | |
| 3 | 1. Call the Service Mode to the screen. 2. Touch [System] → [Software Switch Setting]. 3. Touch [Mode Selection], enter the mode number “882” using 10-key pad. 4. Touch [Bit Selection], and change the setting to [Mode 3]. 5. Touch [Apply]. 6. Touch [OK]. |
OK | — |
| NG | Go to step 4. | ||
| 4 | 1. Call the Service Mode to the screen. 2. Touch [System] → [Software Switch Setting]. 3. Touch [Mode Selection], enter the mode number “882” using 10-key pad. 4. Touch [Bit Selection], and change the setting to [Mode 4]. 5. Touch [Apply]. 6. Touch [OK]. |
— | — |
| 5 | 1. Call the Service Mode to the screen. 2. Select [Machine Adjustment] → [Fusing Temperature] → [Heater Roller]. 3. Select a paper type. 4. Change the temperature of Heater Roller to [-10 °C]. |
OK | — |
| NG | Go to step 6 | ||
| 6 | 1. Call the Service Mode to the screen. 2. Select [Machine Adjustment] → [Fusing Temperature] → [Pressure]. 3. Select a paper type. 4. Change the temperature of Heater Roller to [-20 °C]. |
— | — |