Konica-Minolta bizhub 7616v

MAINTENANCE COUNT

Functions

• To enter an appropriate counter value (0 to 999999) as the tentative maintenance time.
• Specify the setting on maintenance counter to “1” or “2”: If the maintenance life is reached, the maintenance call (M1) or service call [Call Service (M1)] will appear.
  NOTE
  ▪ The counter value is decremented until it reaches -999999 even after it has counted 0.

Setting/ Procedure

• The default setting is 0.
  “0” : Not counted
  1 : Counted (The maintenance call display is given when the counter reaches 0.)
  2 : Counted (The service call display is given and the initiation of any new copy cycle is inhibited when the counter reaches 0.)
• When “1” or “2” is selected, a screen will then appear to allow the counter value to be entered.

IU LIFE STOP MODE

Functions

• When the supplies life count. reaches the life value, the IU life will be detected.
• The mode when the IU life is reached, is specified by this setting.
  CONTINUOUS :
  Enables copying. Maintenance call display is given.
  STOP :
  Disables copying. service. call display is given and the initiation of any new copy cycle is inhibited.
  NOTE
  ▪ The counter value is decremented until it reaches -999999 even after it has counted 0. In this case, however, no image quality is guaranteed.

Setting/ Procedure

• The default setting is CONTINUOUS.